1. For design of a column the eccentricity of loading shall be taken as the distance from the assumed point of application of the load to the centroid of the column, subject to a minimum of
2. Rewrite as directed: 'To beat the air' approximately means (Meaning of the phrase in italics)?
3. India’s first fast breeder neutron reactor is?
4. The Industrial Revolution gave rise to .........?
5. The concrete is deemed not to comply with the strength requirements if the strength is less than the greater of
6. The maximum area of compression reinforcement in a beam of cross section B x D is limited to
7. Moist curing of the exposed surfaces of concrete is done at least for
8. If the ratio of effective span to overall depth of a simply supported beam is equal or greater than 1 but less than or equal to 2, the lever arm, is
9. If the slenderness ratio of a column is more than 160, the compressive stress obtained by the secant formula is multiplied by a factor in which value of x is
10. For battened struts, the effective length is increased by
11. Shankaracharya did not establish ‘Math’ in?
12. The test strength of the sample is taken as the average of the strength of
13. The maximum deflection of a structure should not normally exceed lesser of the span/350 or
14. Pick up the correct statement regarding columns.
15. For heavily reinforced concrete member, the nominal maximum size of the aggregates should be restricted to
16. The minimum pitch i.e., the distance between centres of rivet holes is not less than
17. Dispersion of load through the flange to web is considered as dispersed uniformly at an angle θ° is
18. The grade of concrete generally not used in the reinforced concrete, is
19. The outstand of stiffeners should be (where t is the thickness of flat).
20. For the plain reinforcing bars in compression, the permissible design bond stress in tension, is increased by
21. The cover to the main reinforced may be reduced up to one third of the specified cover but not less than
22. The maximum compressive strength on 15 cm cubes of M 20 grade concrete at 7 days, should be a minimum of
23. The reduced level of third floor of a building near a column is 205.350 m. The reduced levels of the undersides of four beams supporting the fourth floor framing into the column mutually perpendicular are 208.350 m, 208.450 m, 208.500 m and 208.550 m. The supported length of the column is
24. The distance between, rivet line and the nearest edge of a joint not exposed to weather, is taken (where t is thickness in mm of the thinner outside plate).
25. Pick up the correct precaution while spilicing the reinforcing bars