networking-virtual-lans Related Question Answers

1. When a new trunk link is configured on an IOS-based switch, which VLANs are allowed over the link?


2. Which of the following modes are valid when a switch port is used as a VLAN trunk? Blocking Dynamic auto Dynamic desirable Nonegotiate Access Learning





3. To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.





4. You want to improve network performance by increasing the bandwidth available to hosts and limit the size of the broadcast domains. Which of the following options will achieve this goal?





5. Which switching technology reduces the size of a broadcast domain?





6. Which of the following provide inter-switch VLAN communication? ISL VTP 802.1Q 802.3Z





7. A switch has been configured for three different VLANs: VLAN2, VLAN3, and VLAN4. A router has been added to provide communication between the VLANs. What type of interface is necessary on the router if only one connection is to be made between the router and the switch?





8. Which of the following are benefits of VLANs? They increase the size of collision domains. They allow logical grouping of users by function. They can enhance network security. They increase the size of broadcast domains while decreasing the number of collision domains. They simplify switch administration. They increase the number of broadcast domains while decreasing the size of the broadcast domains.





9. Which of the following protocols are used to configure trunking on a switch? VLAN Trunk Protocol VLAN 802.1Q ISL





10. What VTP mode allows you to change VLAN information on the switch?





11. You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?





12. Which of the following is an IEEE standard for frame tagging?





13. Which of the following is true regarding VLANs?





14. Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?





15. Which of the following is true regarding VTP?





16. Which of the following commands sets a trunk port on a 2960 switch?





17. Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?






Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution