Active power in 3 phase circuit is: ?->(Show Answer!)

Question Set

1. Active power in 3 phase circuit is:

Show Similar Question And Answers

QA->In the shortest phase of mitosis the separation of newly formed chromosomes occurs. Which is that phase?....

QA->At the time of short-circuit; what will be the current in the circuit?....

QA->At the time of short-circuit, what will be the current in the circuit?....

QA->Neap tides occur during which phase of the moon?....

QA->Which is the phase that invades but does not destroy the lost?....

MCQ->A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be....

MCQ->Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

MCQ->In a phase discriminator fc, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are exactly 90° out of phase when input frequency is fcmore than 90° out of phase when input frequency is higher than fcless than 90° out of phase when input frequency is lower than fc Which of the above statements is correct?....

MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....

MCQ->Match the following: List I (Circuits) List II (Output dc voltage)A.Single phase half wave converter1.B.Fully controlled bridge converter (1 phase) with RLE load2.C.3 Phase full converter3.D.Single phase full wave converter (M-2) connection4.

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution