The pressure at the bottom of a liquid tank does not depend on which area? ?->(Show Answer!)

1. The pressure at the bottom of a liquid tank does not depend on which area?

Answer: Area of the liquid surface

Tags

Show Similar Question And Answers

QA->The pressure at the bottom of a liquid tank does not depend on which area?....

QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....

QA->The escape velocity from the surface of the earth does not depend on which body?....

QA->The escape velocity from the surface of the earths does not depend on?....

QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....

MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)...

MCQ->Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)...

MCQ->A and B are two taps which can fill a tank individually in 10 minutesand 20 minutes respectively. However, there is a leakage at the bottom which can empty a filled tank in 40 minutes. If the tank is empty initially, how much time will both the taps take to fill the tank (leakage is still there) ?...

MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution