Question Set

1. For designing end bearing piles of square cross-section in clays having average unconfmed compressive strength of 6 t/m2, the net ultimate bearing capacity may be taken as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
QA->The average salary of all the workers in a workshop is Rs. The average salary of 7 technicians is Rs.12000 and the average salary of the rest is Rs. How many workers are there in the workshop ?....
QA->The average of six numbers is x and the average of three of these is y. If the average of the remaining three is z, then....
QA->The average score of a cricketer for ten matches is 9 runs. If the average for the first six matches is 42, what is the average for the last four matches?....
QA->In trial average method, the average of 20 numbers is assumed to be The sum of deviations of the numbers from 24 is found to be What is the average?....
MCQ->For designing end bearing piles of square cross-section in clays having average unconfmed compressive strength of 6 t/m2, the net ultimate bearing capacity may be taken as....
MCQ->A rectangular footing 1 m x 2 m is placed at a depth of 2 m in a saturated clay having an unconfined compressive strength of 100 kN/m2. According to Skempton, the net ultimate bearing capacity is....
MCQ->For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75 cm square with a minimum thickness of....
MCQ->For the strip footing on a saturated clay, for the given failure surface as shown in the below figure, the bearing capacity equation takes the form : (where Cu - undrained shear strength φu - angle of internal friction B - width of strip footing qc - ultimate bearing capacity of soil) ....
MCQ->At a cross-section of a beam, the maximum compressive stress at top is 800 kg/cm2 and its maximum tensile stress at bottom is 200 kg/cm2. The depth of cross-section is 10 cm. The depth of the neutral axis from the top of the section is n. The n is equal to....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution