Question Set

1. Water is to be pumped at the rate of 0.025 m3/s from a 4 m deep ground level tank to an overhead tank. The difference in levels of the full tank levels of these tanks is 16 m. What is the approximate power required for operating a 65% efficient centrifugal pump ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an examination A obtains 48 % of full marks and B obtains 33% of full marks. Together they get 567 marks. Find the full marks :....
QA->are based on the principle that the rate of water absorption is essentially equal to the rate of water loss?....
QA->Water evaporates at atmospheric pressure at a certain rate. If now the some water is placed in vaccum. The rate of evaporation?....
QA->The economic condition in which the rate at which the general level of prices for goods and services is rising and subsequently; purchasing power is falling is called?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
MCQ->Water is to be pumped at the rate of 0.025 m3/s from a 4 m deep ground level tank to an overhead tank. The difference in levels of the full tank levels of these tanks is 16 m. What is the approximate power required for operating a 65% efficient centrifugal pump ?....
MCQ->A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062. ....
MCQ->To pump water from a water reservoir 3 m deep and maximum water level at 135 m, a pump is installed to lift water up to R.L. 175 m at a constant rate of 36, 00, 000 litres per hour. If the length of the pipe is 1506 m and f = 0.01, ignoring other minor losses and assuming the economical diameter from Lea's formula D = 1.2 Q , the water horse power of the pump is....
MCQ->Two completely penetrating wells are located L (in metres) apart, in homogeneous confined aquifer. The drawdown measured at the mid point between the two wells (at a distance of 0.5 L from both the wells) is 2.0 m when only the first well is being pumped at the steady rate of Q1 m3/sec. When both the wells are being pumped at identical steady rate of Q2 m3/sec, the drawdown measured at the same location is 8, 0 m. It may be assumed that the drawdown at the wells always remains at 10.0 m when being pumped and the radius of influence is larger than 0.5 L Q1/Q2 is equal to....
MCQ->Which three statements are true about the operation of a full-duplex Ethernet network? There are no collisions in full-duplex mode. A dedicated switch port is required for each full-duplex node. Ethernet hub ports are preconfigured for full-duplex mode. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting. The host network card and the switch port must be capable of operating in full-duplex mode.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution