Question Set

1. Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
QA->Present ages of Kiran and Syam are in the ratio of 5 : 4 respectively. Three years hence, the ratio of their ages will become 11 : 9 respectively. What is Syam"s present age in years?....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
MCQ->Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
MCQ->A simply supported beam of uniform cross-section is subjected to a maximum bending moment of 2.25 t.m. If it has rectangular cross-section with width 15 cm and depth 30 cm, then the maximum bending stress induced in the beam will be....
MCQ->A fixed beam and a simply supported beam having same span and develop same maximum bending moment due to uniformly distributed load on entire span. What is the ratio of uniformly distributed load on fixed beam to that on simply supported beam ?....
MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution