Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in kerala-psc-questions-in-malayalam
Multiple Choice Question in kerala-psc-questions-in-malayalam
Multiple Choice Question in electronics-and-communication-engineering-electronic-devices-and-circuits
Multiple Choice Question in database-sql-for-database-construction-and-application-processing
Multiple Choice Question in 035/2016
Question Answer in Antonyms
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
1. In the design of RCC water tanks,the allowable bending tensile stress for M25 concrete in N/mm2 is:
(A): 1.2
(B): 1.4
(C): 1.8
(D): 2.0
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The place in Tamil Nadu famous for the manufacturing of battle tanks?....
QA->Tensile of metals means?....
QA->Heating rubber with sulphur for the betterment of its properties like tensile strength; hardness; elasticity etc. is called as?....
QA->The bending of light when a ray of light travels from one medium to another is called.?....
QA->The bending of light around the corners of an obstacle or aperture into the region of geometrical shadow of the obstacle is called?....
MCQ->In the design of RCC water tanks,the allowable bending tensile stress for M25 concrete in N/mm2 is:....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
MCQ->Consider the following statements : For an over-reinforced (singly reinforced) rectangular RC section. 1. the lever arm will be less than that for a balanced section. 2. the maximum stress developed by steel would equal the allowable stress in steel. 3. the maximum stress developed by concrete would equal allowable stress in concrete. Of these statements :....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
MCQ->A pre-tensioned concrete member of section 200 mm x 250 mm contains tendons of area 500 mm2 at centre of gravity of the section. The prestress in the tendons is 1000 N/mm2. Assuming modular ratio as 10, the stress (N/mm2) in concrete is....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution