Question Set

1. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole?....
QA->As per the revised Goods and Services Tax (GST) norms, the GST on Haj and Kailash Mansarovar Yatra has been reduced from 18 per cent to how much per cent?....
QA->Which rubber gives high tear resistance?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
MCQ->Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)....
MCQ->The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and σt, τ and σc = Permissible tensile, shearing and crushing stresses respectively)....
MCQ->A mild steel flat subjected to a tensile force of 84 tonnes is connected to a gusset plate using rivets. If the forces required to shear a single rivet, to crush the rivet and to tear the plate per pitch length are 5000 kg, 8000 kg and 6000 kg respectively, then the number of rivets required is....
MCQ->A structural member carrying a pull of 700 kN is connected to a gusset plate using rivets. If the pulls required to shear the rivet, to crush the rivet and to tear the plate per pitch length are respectively 60 kN, 35 kN and 70 kN, then the number of rivets required will be....
MCQ->In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution