Question Set

1. On detail drawings, the worm and gear are usually drawn in the same detail drawing.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->P can do a work in 24 days. Q can do the same work in 9 days and R can do the same in 12 days. Q and R start the work and leave after 3 days. P finishes the remaining work in --- days.....
QA->6 men and 8 women can complete a work in 10 days. 26 men and 48 women can finish the same work in 2 days. 15 men and 20 women can do the same work in - days.....
QA->If two bodies of different masses, initially at rest, are acted upon by the same force for the same time, then the both bodies acquire the same?....
MCQ->On detail drawings, the worm and gear are usually drawn in the same detail drawing.....
MCQ->In working drawings for worm gears, gear teeth are omitted and the gear blank is represented conventionally.....
MCQ->Gear A has a weight of 1.5 lb, a radius of 0.2 ft, and a radius of gyration of ko = 0.13ft. The coefficient of friction between the gear rack B and the horizontal surface is = 0.3. If the rack has a weight of 0.8 lb and is initially sliding to the left with a velocity of (vB)2 = 8 ft/s to the left. Neglect friction between the rack and the gear and assume that the gear exerts only a horizontal force on the rack.....
MCQ->In a single threaded worm and worm wheel, the number of teeth on the worm is 50. The diameter of the effort wheel is 100 mm and that of load drum is 50 mm. The velocity ratio is....
MCQ->The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution