Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
A 50 mm diameter rod is to be turned on a lathe at a cutting speed of 30 m/minute.The required spindle speed in rpm should be approximately ?->(Show Answer!)
Question Set

1. A 50 mm diameter rod is to be turned on a lathe at a cutting speed of 30 m/minute.The required spindle speed in rpm should be approximately





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
QA->Arun started walking towards North after walking 30m, he turned left and walked 40m. He then turned left and walked 30m. He again turned left and walked 50m. How far is he from his original position....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->. In a normal person at rest the cardiac output or amount of blood pumped per minute by the left ventricle is approximately—....
MCQ->A 50 mm diameter rod is to be turned on a lathe at a cutting speed of 30 m/minute.The required spindle speed in rpm should be approximately....
MCQ->A mild steel rod having 50 mm diameter and 500 mm length is to be turned on a lathe.Determine the machining lime to reduce the rod to 45 mm in one pass when cutting speed is 30 m/min and a feed of 7 mm/rev is used:....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....
MCQ->It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 r.p.m., then the speed of lead screw will be....
MCQ->Kiran walked 78 meters towards North.From there he turned left and walked 35 meters.Thereafter he turned to his left,walked 30 meters,turned right and walked 5 meters again.Next,he turned left and walked 48 meters and stoppeHow far and in which direction is Kiran now from his starting point?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution