Question Set

1. Which of the following units is usually used to denote the intensity of pollution?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The unit which is usually used to denote the intensity of pollution?....
QA->The Units which are derived from fundamental units?....
QA->What is the number of basic units in the International System of Units?....
QA->In the Vedic society; which was the term used to denote a group of families?....
QA->The term nishka; which meant an ornament in the Vedic period; was used in later tirmes; what did it denote?....
MCQ->Which of the following units is usually used to denote the intensity of pollution?....
MCQ->Which of the following statements in the context of income-environment relationship is correct? 1.pollution trends tend to follow an inverse U shaped relationship across different stages of economic development 2.In the beginning stage,pollution increases due to urbanization and industrialization 3.In the later stage,pollution declines due to structural changes in the service sector Select the correct answer using the codes below....
MCQ->Statement: Drinking water supply to New Bombay has been suspended till further orders from Maharashtra Pollution Control Board following pollution of Patalganga river, caused by discharge of effluents from some chemical industries. Courses of Action: The industries responsible for discharging effluents into the river should be asked to close down immediately. The river water should immediately be treated chemically before resuming supply. The Pollution Control Board should check the nature of effluents being discharged into the river by industries at regular intervals.

....
MCQ->The intensity of pressure at a certain place is 1 kg (f)/m2, the intensity of pressur e in SI units will be....
MCQ->A superheterodyne receiver is to operate in the frequency range 550 kHz - 1650 kHz, with the intermediate frequency of 450 kHz. Let denote the required capacitance ratio of the local oscillator and I denote the image frequency (in kHz) of the incoming signal. If the receiver is tuned to 700 kHz, then....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution