Question Set

1. Different components on the motherboard of a PC processor unit are linked together by sets of parallel electrical conducting lines. What are these lines called?






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....
QA->The temperature most suited for conducting an industrial process involving a reversible reactions; most conveniently and profitably is called?....
QA->The clock rate of a processor is measured in?....
QA->Different forms of the same element with different physical appearances are known as?....
MCQ->Different components on the motherboard of a PC processor unit are linked together by sets of parallel electrical conducting lines. What are these lines called?....
MCQ->Different components on the motherboard of a PC unit are linked together by se ts of parallel electrical conducting lines. What are these lines called?....
MCQ->Read the following statements about sets If A and B are sets then A + B denotes union of sets A and B.The union of A and B is that set whose elements are in either A or B or both.If A and B are sets, then difference of sets A and B is denoted by A - B.A - B in the set obtained by removing elements of A from B. Which of the above are true?....
MCQ->In a cross linked polymer, the monomeric units are linked together to constitute a three dimensional network. Which of the following is a cross-linked polymer ?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution