In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually ?->(Show Answer!)

Question Set

1. In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually

Show Similar Question And Answers

QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....

QA->There are 50 students in a class. In a class test 22 students get 25 marks each, 18 students get 30 marks each. Each of the remaining gets 16 marks. The average mark of the whole class is :....

QA->Name the economy in which people work according to the principle ‘from each according to his ability to each according to his needs’?....

QA->Name the set of proofs where each of the process colors is printed separately and in combination with each colors....

QA->Which of these methods involves passing paper through a press twice but using one same plate each time to print two complete signatures on each sheet ?....

MCQ->In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually....

MCQ->Consider the following statements: To draw a.c. equivalent circuit of a transistors, all d.c. sources are shorteda.c. sources are shortedd.c. sources are openeda.c. sources are connected to d.c. sources Which of the above statements is/are correct?....

MCQ->Statement: The General Administration Department has issued a circular to all the employees informing them that henceforth the employees can avail their lunch break at any of the half-hour slots between 1.00 p.m. and 2.30 p.m. Assumptions: The employees may welcome the decision and avail lunch break at different time's slots. There may not be any break in the work of the organization as the employees will have their lunch break at different time slots.

MCQ->A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be....

MCQ->Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution