Question Set

1. If the stirrer speed is too slow, bubbles will accumulate and coalescese under the impeller. This phenomenon is known as a





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Raju Starts from A to B at a speed of 10 km/hr and returns with a speed of 15 km/hr. What is the average speed of the journey ?....
QA->Who said "Three o'clock is always too late or too early for anything you want to do’ ?....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
MCQ->If the stirrer speed is too slow, bubbles will accumulate and coalescese under the impeller. This phenomenon is known as a....
MCQ->For laminar flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)....
MCQ->For turbulent flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei, is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)....
MCQ->Reynolds (Rei) number for the impeller is given by (where Di, stirrer diameter; N, stirrer speed, ρ, density of fluid and μ, viscosity of fluid)....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution