Question Set

1. In the circuit of figure, the source supplies, 2.25 mA. The value of R must be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.07 am
    The current through 8 ohm and 2 ohm resistances is A or 1 mA. Therefore, current through (5 + R) ohm is 1.25 mA.
Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->The electrical potential for a source in a circuit is called?....
QA->To maintain the value of money what must be kept constant?....
QA->Which type of forest belt supplies most of the world’s requirement of newsprint?....
MCQ->In the circuit of figure, the source supplies, 2.25 mA. The value of R must be ....
MCQ->Which two statements are true for any concrete class implementing the java.lang.Runnable interface? You can extend the Runnable interface as long as you override the public run() method. The class must contain a method called run() from which all code for that thread will be initiated. The class must contain an empty public void method named run(). The class must contain a public void method named runnable(). The class definition must include the words implements Threads and contain a method called run(). The mandatory method must be public, with a return type of void, must be called run(), and cannot take any arguments.....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about gm rdReason (R): A common source amplifier is a source follower circuit

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution