Question Set

1. In bending operation, the metal takes the shape of a punch.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The effect of roll bending in calendaring operation is reduced by....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which operation was the continuation of operation Desert storm?....
QA->The bending of light when a ray of light travels from one medium to another is called.?....
QA->The bending of light around the corners of an obstacle or aperture into the region of geometrical shadow of the obstacle is called?....
MCQ->In bending operation, the metal takes the shape of a punch.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The operation of cutting a cylindrical hole in a sheet of metal by the punch and die is called....
MCQ->The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal, is known as....
MCQ->The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution