1. You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is show interfaces, which will provide the IP address and mask for each interface.
Show Similar Question And Answers
QA->ഒരു user-ന്റെ user name, password എന്നിവ login സമയത്ത് റെക്കോഡ് ചെയ്യുന്ന പ്രോഗ്രാമുകൾ? ....
QA->Where in your body is your patella?....
QA->Where in your body is your patella....
QA->Who said ‘Happiness is when what you think; what you say; and what you do are in harmony’?....
QA->Which type of cell has the ability to develop into any type of all?....
MCQ->You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->Your company uses both Ethernet and token-ring LAN's in the same building. Users need access to resources and the ability to transmit data between the LAN's. Which device would you use to enable communications between dissimilar LAN's that use different protocols?....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions