electronic-devices-bipolar-junction-transistors Related Question Answers
2. When a transistor is used as a switch, it is stable in which two distinct regions?
3. The term BJT is short for
4. For a silicon transistor, when a base-emitter junction is forward-biased, it has a nominal voltage drop of
10. What are the two types of bipolar junction transistors?
11. In this circuit DC = 100 and VIN = 8 V. The value of RB that will produce saturation is:
12. The value of DC
15. Refer to this figure. The value of DC = 100 and VIN = 8 V. Determine IC(sat).
16. Which of the following is true for an npn or pnp transistor?
17. What is the order of doping, from heavily to lightly doped, for each region?
18. In what range of voltages is the transistor in the linear region of its operation?
19. The magnitude of dark current in a phototransistor usually falls in what range?
20. A 35 mV signal is applied to the base of a properly biased transistor with an r'e = 8 and RC = 1 k. The output signal voltage at the collector is:
21. What is (are) general-purpose/small-signal transistors case type(s)?
22. What is (are) common fault(s) in a BJT-based circuit?
23. The dc load line on a family of collector characteristic curves of a transistor shows the
24. Refer to this figure. Determine the minimum value of VIN from the following that will saturate this transistor.
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution