Question Set

1. Heat transfer rate per unit area is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The spatial frequency of a wave, either in cycles per unit distance or radians per unit distance is called?....
QA->Transfer of heat from hotter region carrying heat to a colder region is called?....
QA->The rate of transfer of heat is maximum in?....
QA->The force per unit area is called?....
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
MCQ->A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as....
MCQ->Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the....
MCQ->For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area....
MCQ->A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2.°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be....
MCQ->If Damkohler number, NDa >>1, the reaction rate is much greater than the mass transfer rate and the overall reaction is controlled by the rate of mass transfer. In this case, the enzyme reaction can be described as (where Csb and Cs are the substrate concentration in bulk of solution and at the immobilized enzyme surface respectively. ks mass transfer coefficient, and a is the surface area of an immobilized enzyme particles)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution