Question Set

1. In the truss, the force in the member AC is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The Speaker can ask a member of the House to stop speaking and let another member speak. This is known as?....
QA->Who can remove a member of a Co-operative Socitey who become disqualified to continue as a member....
QA->Battle of Water Loo (1815) British force led by Duke of Wellington defeated French force led by ?....
QA->To restrain by force or impel a person by force.....
QA->According to the Periodic Labour Force Survey (PLFS) 2017-18, what percentage of India’s young people (15-29 years) in the labour force are unemployed?....
MCQ->The Prime Minister, at the time of the appointment:1. need not necessarily be a member of one of the Houses of Parliament but must become a member of one of the Houses within six months. 2. need not necessarily be a member of one of the. Houses of Parliament but must become a member of the Lok Sabha within six months. 3. must be either a nominated or elected member of one of the Houses of Parliament. 4. must be an elected member of only Lok Sabha.?....
MCQ->A cantilever pin-jointed truss carries one load P at the point Z as shown in the given figure. The hinges in the vertical wall are at A and D. The truss has only three horizontal members AC, CG and GZ. The nature of force in member AB ....
MCQ->The following two statements are made with reference to the planar truss shown below The truss is statically determinateThe truss is kinematically determinate With refernece to the above statements, which of the following applies ?....
MCQ->A tower used in an electrical substation supports a power line which exerts a horizontal tension of T = 500 lb on each side truss of the tower as shown. Determine the force in members BC, CM, and LM of a side truss and indicate whether the members are in tension or compression.....
MCQ->A force of 500 N acts at the top of the two-member frame. If the members are in smooth contact with one another at A, B, and C with no fasteners, determine the shear force developed at a horizontal section through point D of the support. Also, what are the axial force, shear force and moment at point E?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution