In a shaft, the shear stress is not directly proportional to ?->(Show Answer!)

Question Set

1. In a shaft, the shear stress is not directly proportional to

Show Similar Question And Answers

QA->What is directly proportional to the energy of a photon?....

QA->At constant temperature and pressure the voume of a gas is directly proportional to the number of molecule this law had been given by?....

QA->At constant pressure the volume of a definite mass of a gas is directly proportional to the?....

QA->Decrease of viscosity with increasing shear rate is known as....

QA->In a two roll mill the shear rate is adjusted by....

MCQ->The maximum shear stress in a solid shaft of circular cross-section having diameter d subjected to a torque T is τ. If the torque is increased by four times and the diameter of the shaft is increased by two times, the maximum shear stress in the shaft will be....

MCQ->Consider the following statements : In a uni-dimensional stress system, the principal plane is defined as one on which the 1. shear stress is zero. 2. normal stress is zero. 3. shear stress is maximum. 4. normal stress is maximum. Of these statements :....

MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....

MCQ->The average shear stress in the hollow shaft is smaller than the average shear stress in the solid shaft.....

MCQ->The 2-kg shaft CA passes through a smooth journal bearing at B. Initially, the springs, which are coiled loosely around the shaft, are unstretched when no force is applied to the shaft. In this position s = sª = 250 and the shaft is originally at rest. If a horizontal force of F = 5 kN is applied, determine the speed of the shaft at the instant s = 50 mm, sª = 450 mm. The ends of the springs are attached to the bearing at B and the caps at C and A.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution