Question Set

1. Which of the following is used for input and output both






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which one of the following is an output device?....
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->Which of the following groups consists of only input devices?....
QA->Which input device can not be used to work in MS - OFFICE ?....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->Refer to the display multiplexer given below. The MSD display is blank, while the LSD seems to be OK. The input and output lines to the 74157 and 7449 are checked with a scope and can be seen changing levels. The A input on the 74139 also changes; however, the 0 output on the 74139 is always LOW and the 1 output is always HIGH. The B and EN inputs on the 74139 are always LOW. What could cause the problem and what should be done to correct it?

....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->If γ = (S0/N0)/(Si/Nm) where S0 and S1 are signal power output and signal power input and N0 and Nm are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution