The voltage across a coil when di/dt = 20 mA/s and L = 8 H is ?->(Show Answer!)

Question Set

1. The voltage across a coil when di/dt = 20 mA/s and L = 8 H is

Show Similar Question And Answers

QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....

QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....

QA->The device used for converting current from a lower voltage to a higher voltage is known as?....

QA->The production of ail electromotive force (voltage) across an electrical conductor due to its dynamic interaction with a magnetic field is called?....

QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....

MCQ->A series resonant band-stop filter consists of a 68 resistor, a 110 mH coil, and a 0.02 F capacitor. The internal resistance, RW, of the coil is 4 . Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?....

MCQ->A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.....

MCQ->A coil of wire is placed in a changing magnetic field. If the number of turns in the coil is decreased, the voltage induced across the coil will....

MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....

MCQ->A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution