Question Set

1. An inverting amplifier has R1 = 10 kΩ, and Rf = 150 kΩ then the O/P voltage, if input voltage Vi = 1 volt.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Arjun walks 20 m towards North. Then he turns right and walks 30 ms. Again he turns right and walks 35 ms. Then he turns left and walk 15 ms. How far and in which direction Arjun now from his starting point?....
MCQ->An inverting amplifier has R1 = 10 kΩ, and Rf = 150 kΩ then the O/P voltage, if input voltage Vi = 1 volt.....
MCQ->Calculate the O/P voltage of a non-inverting constant gain multiplier with R1 = 100 kΩ, Rf= 600 kΩ, V1 = 2 volt, then O/P voltage Vo of non inverting op-amp is given by....
MCQ->A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is....
MCQ->Solve the following equation for x, y, and z:x – y + z = –1   –x + y + z = –1   x + 2y – 2z = 5....
MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution