Question Set

1. Y signal has maximum percentage of





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 09.18 pm
    Y = 0.3 R + 0.59 G + 0.11 B.
Show Similar Question And Answers
QA->Which State has the largest percentage of reserved parliamentary seats?....
QA->Which country has the world’s highest percentage of arable land to the total geographical area?....
QA->Which state has the largest percentage of area under forest?....
QA->Which State/Union Territory has the largest percentage of area under forest?....
QA->Which is technique used to transmit audio signal in television broadcasts?....
MCQ->c(t) and m(t) are used to generate an FM signal. If the peak frequency deviation of the generated FM signal is three times the transmission bandwidth of the AM signal, then the coefficient of the term cos [2p (1008 x 103t)] in the FM signal (in terms of the Bessel Coefficients) is....
MCQ->An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be....
MCQ->Consider the following statements : 1. Tests on cement paste to determine initial and final setting times are done at normal consistency condition. 2. Low heat cement has a high percentage to tricalcium aluminate. 3. High early strength portland cement contains a larger percentage of tricalcium silicate and a lower percentage of dicalcium silicate. Which of these statements are correct ?....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions