Question Set

1. In the following network, the switch is closed at t = 0- and the sampling starts from t = 0. The sampling frequency is 10Hz. The expression and the region of convergence of the z-transform of the sampled signal are




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.55 am
    X(Z) = 5.e-0.05n.Z-n .
Show Similar Question And Answers
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->After the attainment of political independence in 1947, Gandhiji felt that the Congress, as a propaganda vehicle and a parliamentary machine, had outlived its usefulness. So to keep the Congress away from unhealthy competition with political parties and communal bodies, Gandhiji towards the end of January 1948 sketched a draft constitution for the Congress to transform itself into ......?....
MCQ->In the following network, the switch is closed at t = 0- and the sampling starts from t = 0. The sampling frequency is 10Hz. The expression and the region of convergence of the z-transform of the sampled signal are....
MCQ->In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 10Hz. The samples x(n) (n = 0, 1, 2, ...) are given by....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.....
MCQ->An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution