If load impedance ZL >> Z0, then ?->(Show Answer!)

Question Set

1. If load impedance ZL >> Z0, then

Show Similar Question And Answers

QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

QA->If a number is increased by 30% and then from the increased number its 30% is decreased. Then :....

QA->You go North. Turn right. Then again and then go to left. In which direction are you now?....

QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....

MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....

MCQ->A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a resistance of 10 . If the load resistance decreases to 7.5 , the load voltage will decrease to 10.9 V. The load current will be ________, and the percent load regulation is ________.....

MCQ->A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is....

MCQ->Consider the following statements Impedance of Gunn diode is about tens of ohms.Impedance of Impatt diode is a few ohms.Impedance of Impatt diode are of the same order.Impedance of Impatt diode is more than that of Gunn diode. Which of the above statement are correct?....

MCQ->Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution