Question Set

1. In a circular waveguide with radius r, the dominant mode is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.05 am
    Some applications require dual polarization capability. Circular waveguide has this capability. These analysis uses cylindrical coordinates. In circular waveguide TE11 mode has the lowest cut off frequency and is the dominant mode. If D is diameter of waveguide λc = 1.706 D for TE11 mode λc = 1.029 D for TE21 mode λc = 0.82 D for TE01 mode λc = 1.306 D for TM01 mode.
Show Similar Question And Answers
QA->Find the maximum velocity for the overturn of a car moving on a circular track of radius 100 m. The co-efficient of friction between the road and tyre is 0.2?....
QA->The ratio between the radius and height of a circular one of volume 314 cm (cube) is 5:Its height is....
QA->In India; in which banking is the Public Sector is most dominant?....
QA->Which area is dominant in hunting and gathering?....
QA->In India, in which banking is the Public Sector is most dominant?....
MCQ->A rectangular waveguide having TE10 mode as dominant mode is having a cut off frequency of 18 GHz for the TE30 mode. The inner broad wall dimension of the rectangular waveguide is....
MCQ->Assertion (A): In TE10 mode the cutoff frequency of rectangular waveguide is where a is the broad dimension and c is velocity of light.Reason (R): TE10 mode is the dominant mode in rectangular waveguide.

....
MCQ->Assertion (A): In circular waveguide the attenuation of TE01 mode decreases as the operating frequency increases.Reason (R): The wall currents in a circular waveguide in TEQ1 mode are completely circumferential.

....
MCQ->Consider the following statements: For a square waveguide of cross-section 3m x 3m it has been found At 6 GHz dominant mode will propagateAt 4 GHz only dominant modes and evanescentAt 11 GHz all the modes and no higher order mode will propagateAt 7 GHz degenerate modes will propagate Which of the above statements are correct?....
MCQ->If RADIUS = 3.0 the result of the following FORTRAN 77 program will be

REAL RADIUS, CAREA, SAREA, RATIO
PI
PI = 3.1416
READ , RADIUS CAREA = PI RADIUS RADIUS
SAREA = 2 RADIUS RADIUS
RATIO = CAREA/SAREA....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution