In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be ?->(Show Answer!)

Question Set

1. In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be

Show Similar Question And Answers

QA->By inserting a soft iron piece into solenoid; what does the strength of the magnetic field?....

QA->By inserting a soft iron piece into solenoid, what does the strength of the magnetic field?....

QA->The unit of magnetic flux density?....

QA->If two bodies of different masses, initially at rest, are acted upon by the same force for the same time, then the both bodies acquire the same?....

QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....

MCQ->In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be....

MCQ->In a specimen of silicon steel, a field strength of 200 A/m causes a flux density of 0.5 T. In a specimen of cast iron, the same H would cause B to be....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->A clay soil specimen when tested in unconfined condition gave an unconfined compressive strength of 100 kN/m2. A specimen of the same clay with the same initial condition is subjected to a UU triaxial test under a cell pressure of 100 kN/m2. The axial stress (in kN/m2) at failure would be....

MCQ->From a homogeneous and isotropic dielectric material of dielectric constant ∈r, a small volume element is taken out creating a cavity. The field can be kept homogeneous if Di. (i.e., electric flux density inside the cavity) and D0 (i.e., electric flux density outside the cavity) are such that....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution