Question Set

1. A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->In the shortest phase of mitosis the separation of newly formed chromosomes occurs. Which is that phase?....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
MCQ->A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque....
MCQ->A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be....
MCQ->Consider the following statements as regards induction and dynamometer wattmeters Dynamometer wattmeters can be used for dc only.Induction wattmeter has higher torque and dynamometer wattmeter.Induction wattmeter is less accurate, has more power consumption and more weight than dynamometer wattmeter. Which of the above statements are correct?....
MCQ->Consider the following statements about variable reluctance stepper motor used in control system The static torque acting on rotor is a function of angular misalignment between stator and rotor teethThere are two positions of zero torque i.e, . Q = 0 and where T is the number of rotor teethBoth zero torque positions are stableWhen stator is excited, rotor is pulled into minimum reluctance position Of these statements, the correct ones are....
MCQ->Match the following: List I (Functional components) List II (Device) A.Error detector1.Three phase FHP Induction motorB.Servo motor2.Synchro transmitter and control transformerC.Amplifier3.Tacho generatorD.Feed back4.Armature controlled FHP dc motor 5.Amplidyne

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution