<<= Back
Next =>>
You Are On Multi Choice Question Bank SET 1067
53351. The source is 24 volts and the load resistance is 100 . What is the load current?
53352. Resistors are identified as to wattage by:
53353. What type of resistors have a tolerance rating of 5% or greater?
53354. Resistor tolerance is either printed on the component, or is provided by:
53355. How many connections does a rheostat have?
53356. What are the parts of a rheostat?
53357. The load resistance increases. How will the load current change?
53358. What is the power dissipated by a 1.2 k resistor with 12 volts across it?
53359. How many joules of energy will a 10 W lamp dissipate in one minute?
53360. Which type of test equipment is used to measure resistors?
53361. Resistance is:
53362. Electrical equipment is protected against excessive current by a(n):
53363. If resistance decreases, then current will:
53364. A wire with a smaller cross-sectional area will produce:
53365. A 22-gauge wire will have a diameter in mils of:
53366. The word work means that:
53367. A good fuse will have:
53368. What property does an incandescent lamp possess?
53369. One advantage of a carbon film resistor over a carbon composition resistor is:
53370. If a metallic conductor has a positive temperature coefficient of resistance, then:
53371. What value of a 1.3 k resistor as measured by a digital voltmeter would be considered within tolerance?
53372. If a calculator display was "0.00263," what would this answer be in percent?
53373. A 33 k resistor with a 20% tolerance checks out as ok with which of the following ohmmeter readings?
53374. For P = V2/R, a decrease in resistance should produce:
53375. After a lamp is turned on, its filament resistance will change to become:
53376. Wirewound resistors are usually used in circuits that have:
53377. How is power dissipated in a resistor?
53378. Resistance in a circuit is:
53379. The unit designator for resistance value is the:
53380. One ampere of current flowing through one ohm of resistance is equal to:
53381. Good insulators:
53382. A 12-volt battery is delivering 3 amperes to a resistor. The power dissipated by the resistor is 4 watts.
53383. Resistance limits the flow of current.
53384. If 500 mA is flowing through a 10 resistor, the wattage rating of the resistor should be 2 watts.
53385. A digital voltmeter can be used to measure resistance.
53386. Carbon composition resistors are the most common and the least expensive type of fixed-value resistor.
53387. In a resistive circuit, if the voltage increases, the current will increase.
53388. A 2% 55 k resistor would have a color coding of green, green, black, red, red.
53389. The resistive track of a rheostat or potentiometer can be classified as having either a linear or tapered resistance.
53390. Resistance is inversely proportional to current.
53391. A rheostat is not a type of variable resistor.
53392. Resistivity is measured in cmil.Ω/ft.
53393. A load resistance is the resistance of the load.
53394. Variable resistors have problems with the wiper making contact.
53395. The maximum potential a material can withstand without rupture is called breakdown voltage.
53396. The cross-sectional area of a conductor is one factor that determines the conductor's resistance to current.
53397. An ohmmeter uses an internal battery to measure the resistance of a resistor.
53398. A protoboard is used to make experimental circuits.
53399. One horsepower is 746 watts.
53400. Fixed-value resistors can internally short-circuit.
<<= Back
Next =>>
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution