<<= Back Next =>>
You Are On Multi Choice Question Bank SET 377

18851. The headquarters of SIDBI is at:





18852. The maximum delivery pressure of compressors can be upto __________ atmospheres.





18853. Which bank has got gold should for excellence in financial reporting in the Private Bank category 2011-2012 from Institute of Chartered Accounts of India?





18854. Dimension of surface tension is(where, F = force, L = length)





18855. SBI associate banks were nationalized on:





18856. Which of the following is not a dimension-less parameter ?





18857. Complaint redressal system launched by SEBI is:





18858. Co-efficient of velocity is __________ the coefficient of discharge.





18859. Accounts are allowed to be operated by cheque in respect of:





18860. All pipes of a particular nominal size have the same





18861. Capacity of the bank to produce cash on demand:





18862. For the transfer of solution of thick slurry, the pump used is a __________ pump.





18863. Earliest Commercial Banks were known as:





18864. Which of the following is not concerned with the fluid-particle interaction ?





18865. 14 Major commercial banks were nationalized on:





18866. Maximum theoretical suction lift for water at 15°C by a centrifugal pump is 34 ft. The same for water at 90°C will be __________ ft.





18867. First organized stock exchange in India was:





18868. The document used by the customers for depositing cash in to bank:





18869. Pressure drag does not depend upon the





18870. Services provided by banks under E-Banking is:





18871. The rate at which Reserve Bank rediscount papers presented by Commercial Bank or make advance to them directly aginst approved securities:





18872. Dimension of absolute viscosity is





18873. Banking Regulation Act passed in:





18874. __________ pumps are axial flow pumps.





18875. Brownian movement is prominent in the particle size range of __________ microns in case of settling of a particle in a fluid.





18876. For a particle settling in water at its terminal settling velocity, which of the following is true ?





18877. A Bingham fluid of viscosity μ = 10 Pa.s and yield stress, τ0 = 10 KPa, is shared between flat parallel plates separated by a distance of 10-3 m. The top plate is moving with a velocity of 1 m/s. The shear stress on the plate is





18878. Which of the following is not a banking term?





18879. Shear stress in a fluid flowing in a round pipe





18880. The resistance wire used in a hot wire anemometer for conducting electrical current is made of





18881. Two dimensional stream function





18882. What causes cavitation in centrifugal pump ?





18883. Draining of shallow pits or sump is done by a sump pump, which is a __________ pump.





18884. A hydraulic ram acts as a/an __________ pump.





18885. The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonion fluid in a circular pipe is





18886. Choose the correct set of dimensions of viscosity that are equivalent (where, F, M, L, T are dimensions for force, mass, length and time respectively).





18887. The line of action of the buoyant force passes through the centre of gravity of the





18888. Which of the following organization was set up to boost the overall rural development in India





18889. The friction factor for turbulent flow in a hydraulically smooth pipe





18890. The pressure at a point in a fluid is not the same in all directions, when the fluid is viscous and





18891. What causes convective acceleration in fluid flow ?





18892. The Stoke's stream function applies to the





18893. Slugging in a fluidised bed can be avoided by using





18894. The ratio of width to depth for the most economical rectangular section in open channel flow is





18895. The simple pitot tube measures the __________ pressure.





18896. Capacity of a hydraulic accumulator is defined in terms of maximum





18897. Three piping networks as shown in the figure are placed horizontally. They are made using identical pipe segments and are subjected to the same pressure drop across them. Assuming no pressure losses at junctions, the flow rates across the three networks are related as Q1 : Q2 : Q3.





18898. With diminishing cross-sectional area in case of subsonic flow in a converging nozzle, the





18899. Boundary layer separation is characterised by one of the conditions given below, where 'Re' is the Reynolds number for the flow. Select the appropriate conditions.





18900. Manometers measure the __________ pressure.





<<= Back Next =>>
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions