1. STEPS IN MITOSIS?

Answer: Prophase 1) Formation and doubling of chromosomes 2) Break down of nuclear envelope 3) Disappearance of nucleolus 4) Movement of centrioles to opposite poles Metaphase 1) Chromosomes lie at the equator 2) Formation of spindle fibers 3) Spindle fibers get attached to the chromosomes. Anaphase 1) Separation of newly formed chromosomes towards opposite poles Telophase 1) Chromosomes elongate and overlap to form chromatin 2) Nucleolus begins to reappear 3) Nuclear envelope forms around each group of

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->STEPS IN MITOSIS?....
QA->Bovery and Flemming observed mitosis in animal cells. Then who first observed mitosis in plant cell?....
QA->Which country removed India from its currency monitoring list of major trading partners after certain developments and steps were taken by India to avert concerns surrounding foreign exchange irregularities?....
QA->“It was alarming and nauseating too see Gandhiji-later Inner Temple lawyer, now a seditious fakier, striding half naked, up to the steps of Viceroy Palace to parley on equal terms with the representative of the king emperor”-Whose words are these?....
QA->The viceroy who took steps for the restoration of Mysore, which had been annexed by William Bentick on the charge of misgovernment, to its ruling family after 50 years of British administration?....
MCQ->The following steps are involved in laying a sewer in a trench : 1. Transferring the center line of the sewer to the bottom trench. 2. Setting sight rails over the trench. 3. Driving pegs to the level of the invert line of the sewer. 4. Placing the sewer of these steps is The correct sequence of these steps is...
MCQ->If R and T are rise and tread of a stair spanning horizontally, the steps are supported by a wall on one side and by a stringer beam on the other side, the steps are designed as beams of width...
MCQ->For transferring the tunnel alignment through shafts, we adopt the following steps : 1. Hanging two or more plumb lines in the shaft 2. Determining the bearing of the plumb lines i.e. plumb plane 3. Suspending a 35 kg weight by each plumb line 4. Immersing the weights of both the plumb lines in the buckets containing water. The correct sequence of steps is :...
MCQ->The following steps are involved in making a spigot and socket joint of cast iron pipes used in water supply systems : 1. Tarred gasket or hemp yarn in wrapped around the spigot. 2. The sipgot end is centered into the socket end of the preceding pipe. 3. A joining ring end is placed around the barrel and against the face of the socket. 4. The gasket or hemp yarn in caulked slightly. 5. Molten pig lead is poured and then caulked. The correct sequence of these steps is...
MCQ->The channel section can be designed on the basis of Lacey's Theory. The steps are mentioned below : 1. Finding out the perimeter 2. Finding out the velocity 3. Calculation of the silt factor 4. Finding out the area What is the correct sequence of the steps ?...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution