_____ is a measure of how close together the lines in a halftone grid are in the printing process. ?->(Show Answer!)

1. _____ is a measure of how close together the lines in a halftone grid are in the printing process.

Answer: LPI

Reply

Comments

Tags

Show Similar Question And Answers

QA->_____ is a measure of how close together the lines in a halftone grid are in the printing process.....

QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....

QA->A can do a piece of work in 4 hours . A and C together can do it in just 2 hours, while B and C together need 3 hours to finish the same work. B alone can complete the work in --- days.....

QA->An electronic device makes a beep after 60 sec.Another device makes a beep after ever 62sec.They beeped together at 10am.The time when they will next make a beep together at the earliest,is....

QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....

MCQ->---------is a measure of how close together the lines in a halftone grid are in the printing process...

MCQ->Consider the following statements : In water supply distribution network, 1. the grid-iron system requires more length of pipe lines and larger number of cut-off valves. 2. the design of the grid-iron system is difficult but economical. 3. employing a grid-iron system, the dead ends are completely eliminated. 4. employing a grid-iron system permits more water to be diverted towards the affected point from various directions. Which of the statements given above are correct ?...

MCQ->Statement: The entire north India, including Delhi and the neighbouring states remained 'powerless' the whole day of 19th December as the northern grid supplying electricity to the seven states collapsed yet again. Assumptions: The northern grid had collapsed earlier. The grid system of providing electricity to a group of states is an ineffective type of power supply system.

MCQ->In how many days can B alone complete the work A,B, and C together can complete the work in 4 32/37 days. A and B together can complete the work in 6 2/3 days, B and C together can complete the work together in 8 2/11 days and A and C together can complete the work in 7 1/3 days....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution