Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The multipurpose project irrigating maximum area in India is ?->(Show Answer!)
Question Set

1. The multipurpose project irrigating maximum area in India is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The Cabinet Committee on Economic Affairs (CCEA), chaired by the Prime Minister Narendra Modi has approved the expenditure on pre-investment activities and various clearances for Dibang Multipurpose Project (MPP) for an amount of Rs 1600 crore. This project will come up in which state?....
QA->Which is the first multipurpose river valley project of independent India?....
QA->The Matatila multipurpose project is located in which state?....
QA->On which river are Tikarpara and Jaraj dams constructed under a multipurpose project?....
QA->Name the Multipurpose Project for which an agreement was signed on 11th January 2019 among the states of Uttar Pradesh, Haryana, Himachal Pradesh, Delhi, Rajasthan and Uttarakhand?....
MCQ->The multipurpose project irrigating maximum area in India is....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->The area of a plot is to be determined using Simpson's rule. The following offsets were taken to a boundary from points along a chain line all measurements being in metres 12, 15, 22, 29, 36, 38, 31, 22, 17.There were taken at 100 m intervals. Consider the following steps in this regard. 1. 2. Sum of the odd ordinates = 22 + 36 + 1 = 89 3. Sum of the even ordinates = 15 + 29 + 38 + 22 = 104 4. 12 + 17 = 39 5. Area = 100 (19.5 + 89 + 104) 6. Area = (39 + 2 x 89 + 4 x 104) 7. Area 100 x 19.5 (104 - 89) The area of the plot can be determined by using the steps listed above :....
MCQ->Which of the following are true regarding OSPF areas? You must have separate loopback interfaces configured in each area. The numbers you can assign an area go up to 65,535. The backbone area is also called area 0. If your design is hierarchical, then you don't need multiple areas. All areas must connect to area 0.....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution