Which one of the following is a simplest linear polymer ? ?->(Show Answer!)

Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Which one of the following is a simplest linear polymer ? ?->(Show Answer!)

Question Set

1. Which one of the following is a simplest linear polymer ?

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->Who exhorted the world famous dictum "One caste, One religion, One clan, One world, One God"?....

QA->Coefficient of linear expansion always …….. with the increase in temperature?....

QA->“One caste, One religion and One God for man of the same blood and form, there is no difference animals of the same caste alone procreate Viewed thus all humanity belong to one caste”- In which book of Sree Narayana Guru these words can be seen?....

QA->The year in which Sree Narayana Guru gave the message ‘One caste, one religion, one god for man’ at a conference held at ‘Adwaithasramam’, Aluva?....

QA->In which year Sree Narayana Guru convened an Inter-religious conference at Aluva where he gave the noble message of "One cast,One religion and One God for men?....

MCQ->Which one of the following is a simplest linear polymer ?....

MCQ->Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->Pick out thể one word for - a secret arrangement....

MCQ->In a linear polymer, the monomeric units are linked together to form long straight chains. The cross linked or branched chain polymers compared to linear polymers have higher....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution