Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
For fairly thick bars of metals ?->(Show Answer!)
Question Set

1. For fairly thick bars of metals





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The scientist who classified elements into Metals and Non-metals is?....
QA->Elements showing properties of both metals and non-metals are?....
QA->Who Classified Elements as Metals and non-metals?....
QA->The study of metals and the overall process by which metals are extracted from its ores are called?....
QA->The elements which show the properties of both metals and non metals are called?....
MCQ->For fairly thick bars of metals....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....
MCQ->S1: Metals are today being replaced by polymers in many applications. P : Above all, they are cheaper and easier to process making them a viable alternative to metals. Q : Polymers are essentially a long chains of hydrocarbon molecules. R : Today polymers as strong as metals have been developed. S : These have replaced the traditional chromium-plated metallic bumpers in cars. S6: Many Indian Institutes of science and Technology run special programmes on polymer science. The Proper sequence should be:....
MCQ->While investigating the site, a thick layer of fairly firm clay over a deep layer of soft clay is encountered. In such a situation, the following type of foundation is useful :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution