Question Set

1. The disposal method in which solid waste is heated in an oxygen free atmosphere and reduced to gseous,liquid and solid fractions:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The best method of refuse disposal is....
QA->The property of a liquid by which the free surface of liquid acts like a stretched membrane?....
QA->What is the name of entrepreneur groups formed under Kudumbashree for the municipal solid waste management?....
QA->For pasteurisation of milk by Flash method; at which temperature is milk heated?....
QA->For pasteurisation of milk by Flash method, at which temperature is milk heated?....
MCQ->The disposal method in which solid waste is heated in an oxygen free atmosphere and reduced to gseous,liquid and solid fractions:....
MCQ->Various methods used by plants to get rid of their waste products are: I. Gaseous waste through stomata and lenticels. II. Stored solid and liquid waste by shedding leaves, peeling of bark and falling of fruits. III. By secreting waste in the form of gum and resins. Which of the following statements is/are correct?....
MCQ->Melting point & boiling points of liquid oxygen are respectively - 218.8°C & - 183°C, while the same for liquid nitrogen is - 210°C & - 195.8°C respectively. The difference in melting points of liquid oxygen & liquid nitrogen is not equal to 8.8....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In a BOD test, 5 ml of waste is added to 295 ml of aerated pure water. Initial dissolved oxygen (D.O) content of the diluted sample is 7.8 mg/l. After 5 days of incubation at 20°C, the D.O. content of the sample is reduced to 4.4 mg/l. The BOD of the waste water is :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution