Question Set

1. Common rail injection system uses injection pressure of the order:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A ruler or boss who uses force in order to make people obey him....
QA->Which winds are flowing from sub tropical high pressure to sub polar low pressure?....
QA->Blood pressure is the pressure exerted on the wall of which part?....
QA->A small weight is put on the pressure cooker. It increases the pressure of the steam. Why?....
QA->Of the four locations mentioned below the highest inside temperature will be attained in the pressure cooker operated with the pressure valve open?....
MCQ->Common rail injection system uses injection pressure of the order:....
MCQ->Wearing locations of rails and their reasons are listed below : 1. Wear at end of rails : Loose fish bolts 2. Wear at sides of rail head : Constant lerake application 3. Wear on the top of rail head on tangent truck : Rigidity of wheel base 4. Wear on top of rail head on curves : Lesser area of contact between wheel and rail Which of the pairs given above are correctly matched ?....
MCQ->Statement: The air and rail services have been severely disrupted due to thick fog in the northern part of the country. Courses of Action: The rail and air services should be temporarily suspended in the region. People should be advised to make their travel plan keeping in mind the probable disruption resulting in delay or cancellation of services. The government should immediately install modern machines which will enable it to guide the rail and air services even if the thick fog develops.

....
MCQ->Read the following statements as regards register pairs in microprocessor 8085B represents B, C pair with B as high order register and C as low order register.D represents D, E pair with D as high order register and E as low order register.H represents H, L pair with H as high order register and L as low order register. Which of the above statements are correct?....
MCQ->Consider the following statements about 8085 The instruction LDA uses direct addressing mode.The instruction MVI uses direct addressing mode.The instruction MVI uses immediate addressing mode.The instruction LDA uses immediate addressing mode. Which of the above are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution