Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The tool used to measure the clearance between two surfaces is called: ?->(Show Answer!)
Question Set

1. The tool used to measure the clearance between two surfaces is called:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The tool used to measure the thicknes,of sheet is called....
QA->A transparent medium bounded by two surfaces atleast one of which is curved surface is called?....
QA->The sum of squares of two numbers is 80 and the square of difference between the two numbers is Find the product of two numbers.....
QA->The substances which reduce the frictional force between moving surfaces?....
QA->The force between a magnet and a magnetic material or between two magnets is called?....
MCQ->The tool used to measure the clearance between two surfaces is called:....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In order to check the clearance between two mating surfaces, a __________ gauge should be used.....
MCQ->Gauges used for checking the clearance between mating surfaces:....
MCQ->A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm2), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution