To anneal hard steel,the steel must be heated above its critical temperature and then: ?->(Show Answer!)

Question Set

1. To anneal hard steel,the steel must be heated above its critical temperature and then:

Show Similar Question And Answers

QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....

QA->In the hard ticks the dorsum of its body is covered by a hard shield is called....

QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....

QA->The length of a rectangular floor is 2 meters more than its width and its perimeter is 20 meters, then its area is....

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

MCQ->To anneal hard steel,the steel must be heated above its critical temperature and then:....

MCQ->If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->Read the following passage carefully and choose the most appropriate answer to the question out of the four alternatives. In short, to write a good letter you must approach the job in the lightest and most casual way. You must be personal, not abstract. You must notsay, 'This is too small a thing to put down'. You must say, 'This is just the sort of small thing we talk about at home. If I tell them this they will see me, as it were they'll hear my voice, they'll know what I'm talking about'. That is the purpose of a letter. Carlyle had the trick to perfection. He is writing from Scotsbrig to his brother Alec in Canada and he begins talking about his mother. Good old Mother, he says, 'she is even now sitting at my back, trying at another table to write you a small word with her own hand the first time she has tried such a thing for a year past. It is Saturday night, after dark we are in the east room in a hard, dry evening with a bright fire to our two selves Jenny and her Barns are 'scouring up things' in the other end of the house and below stairs the winter operations of the farm go on, in a subdued tone you can conceive the scene! How simple it is and yet how perfect. Can not you see Alec reading it in his far-off home and his eyes moistening at the picture of his old mother sitting and writing her last message to him on earth? Subdued tone means _______.....

MCQ->In full annealing, the hypo-eutectoid steel is heated from 30° C to 50° C above the upper critical temperature and then cooled....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution