Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
When a piece of high-carbon steel is heated to red hot,then plunged into cold water it will be: ?->(Show Answer!)
Question Set

1. When a piece of high-carbon steel is heated to red hot,then plunged into cold water it will be:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The pH of water at 25°C is When it is heated to 100°C; then what will be the pH of water?....
QA->The pH of water at 25°C is When it is heated to 100°C, then what will be the pH of water?....
QA->Read the statements carefully and answer the question which follow: A cube has six sides each of a different colour.The red side is opposite black.The green side is between red and black.The blue side is adjacent to white .The brown side is adjacent to blue.The red side is face down.The side opposite brown is:....
QA->To get into hot water....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
MCQ->When a piece of high-carbon steel is heated to red hot,then plunged into cold water it will be:....
MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Consider the following statements regarding tensile test diagrams for carbon steel with varying carbon contents : As the carbon content increases 1. the ultimate strength of steel decreases 2. the elongation before fracture increases 3. the ductility of the metal decreases 4. the ultimate strength increases. Of these statements :....
MCQ->A dumpy level is set up with its eye-piece vertically over a peg A. The height from the top of peg A to the centre of the eye-piece is 1.540 m and the reading on peg B is 0.705 m. The level is then setup over B. The height of the eye-piece above peg B is 1.490 m and a reading on A is 2.195 m. The difference in level between A and B is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution