The operation of removing the burr of the drop forged parts is known as: ?->(Show Answer!)

Question Set

1. The operation of removing the burr of the drop forged parts is known as:

Show Similar Question And Answers

QA->On a clean glass plate a drop of water spreads to form a thin layer whereas a drop of mercury remains almost spherical because?....

QA->The default lines to drop for Drop cap is ______....

QA->The default lines to drop for drop cap is:....

QA->Which among the following rays help to detect forged bank notes in shops?....

QA->Which operation was the continuation of operation Desert storm?....

MCQ->The operation of removing the burr of the drop forged parts is known as:....

MCQ->The following operations are generally employed for tunnelling in hard rock. 1. Removing ground water, 2. Loading holes and firing the explosive 3. Setting up and drilling 4. Grouting and lining 5. Removing muck 6. Ventilation and removing explosion dust The correct sequence is :....

MCQ->The drop hammer H has a weight of 900 lb and falls from rest. H has a weight of 900 lb and falls from rest h = 3 ft onto a forged anvil plate P that has a weight of 500 lb. The plate is mounted on a set of springs which have a combined stiffness of kT = 500 lb/ft. Determine (a) the velocity of P and H just after collision and (b) the maximum compression in the springs caused by the impact. The coefficient of restitution between the hammer and the plate is e = 0.6. Neglect friction along the vertical guide posts A and B.....

MCQ->Consider the following statements : 1. Pumps in series operation allow the head to increase. 2. Pumps in series operation increase the flow rate. 3. Pumps ill parallel operation increase the flow rate. 4. Pumps in parallel operation allow the head to increase. Which of these statements are correct ?....

MCQ->A mild steel bar is in three parts, each 20 cm long. The diameters of parts AB, BC and CD are 2 cm, 1 cm and 3 cm respectively. The bar is subjected to an axial pull of 4t as shown in the given figure. If E = 2 x 106 kg/cm2 and the elongations in the three parts of the bar are Δ1, Δ2 and Δ3 respectively, then the ratio of the greatest to the least of these elongations will be

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution