Question Set

1. In which metal forming process the material is shaped by means of intermittent blows on it.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In a certain code 743 means Mangoes are good; 657 means Eat good food; and 934 means Mangoes are ripe. Which digit means ripe in that language?....
QA->If + means × , - means † , × means - and † means + then 16 – 4 + 3 × 5 ÷ 2 =....
QA->If ‘+’ means ‘×’, ‘__‘ means ‘+’, ‘×’ means ‘÷’ and ‘÷’ means ‘__‘ then find the value of; 6 – 9 + 8 × 3 ÷ 20 = ……. .....
QA->If + means , x means -, means + and - means x. Find 168x6-2+12?....
QA->If P means / , T means +, M means -, and D means x, then what will be the value of the expression 12M12D28P7T15?....
MCQ->In which metal forming process the material is shaped by means of intermittent blows on it.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In a liquid limit test, the moisture content at 10 blows was 70% and that at 100 blows was 20%. The liquid limit of the soil, is....
MCQ->Consider the following statements in regard to aerobic and anaerobic treatment processes : 1. Biomass production in the aerobic treatment process is more as compared to the anaerobic treatment process. 2. Start-up period is more in the aerobic treatment process as compared to the anaerobic treatment process. 3. Energy consumption and production is more in the aerobic treatment process as compared to the anaerobic treatment process. Which of the statements given above is/are correct ?....
MCQ->Consider the following statements If ensemble and time averages of a random process are identical, the process is ergodic.If ensemble and time average of a random process are not identical, the process is ergodic.An ergodic process is stationary.A stationary process is necessarily ergodic. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution