Question Set

1. Which tongs are used for holding bars vertically?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Hammer and tongs....
QA->Which of the following Writs can be used against a person believed to be holding a public office he is not entitled to hold?....
QA->All type bars rest in the....
QA->The semicircular arrangement of type bars on the segment helps in....
QA->How many time in a year Sun shines vertically on the equator?....
MCQ->Which tongs are used for holding bars vertically?....
MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....
MCQ->Tongs is used for:....
MCQ->The "Back sight" reading on a vertically held staff at a point A on the floor along the centre line of a railway tunnel is 3.465 m, and the "Fore sight" on the inverted staff held at the roof of the tunnel just vertically above A is 1.115 m. The height of the tunnel along the centre line at floor point A is....
MCQ->The potential energy of a vertically raised body is __________ the kinetic energy of a vertically falling body.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution