Question Set

1. Filler material used in welding should have __________ as compared to the parent metal to be welded.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->Which is used as a filler in rubber tyres?....
QA->Which is used as a filler in rubber tyres ?....
QA->Name the calcium compound which is used as filler in paper industry?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Filler material used in welding should have __________ as compared to the parent metal to be welded.....
MCQ->When two metal pieces of different thicknesses are to be welded by projection welding, then the projections should be made on __________ metal piece.....
MCQ->In laundry soaps, a material called 'filler' is used. Which of the following is a 'filler'?....
MCQ->In fore-hand welding, the angle between the welding torch and the work is __________ as compared to back-hand welding.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution