__________ joint is usually used for joining cast iron pipes mostly used for temporary pipelines, where it may be necessary to dismantle & reassemble the pipeline very frequently. ?->(Show Answer!)

Question Set

1. __________ joint is usually used for joining cast iron pipes mostly used for temporary pipelines, where it may be necessary to dismantle & reassemble the pipeline very frequently.

Show Similar Question And Answers

QA->Prime Minister Narendra Modi recently inaugurated South Asia’s first cross-border oil pipeline. The pipeline will connect India with which nation?....

QA->Water pipes break in winter in cold regions due to?....

QA->What is meant by ‘Underwriting’; the term frequently used in financial sector?....

QA->What is meant by ‘Underwriting’, the term frequently used in financial sector?....

QA->The two elements that are frequently used for making transistors are?....

MCQ->__________ joint is usually used for joining cast iron pipes mostly used for temporary pipelines, where it may be necessary to dismantle & reassemble the pipeline very frequently.....

MCQ->What will be the output of the program? #include<stdio.h> int main() { int i=4, j=-1, k=0, w, x, y, z; w = i || j || k; x = i && j && k; y = i || j &&k; z = i && j || k; printf("%d, %d, %d, %d\n", w, x, y, z); return 0; }....

MCQ->The following steps are involved in making a spigot and socket joint of cast iron pipes used in water supply systems : 1. Tarred gasket or hemp yarn in wrapped around the spigot. 2. The sipgot end is centered into the socket end of the preceding pipe. 3. A joining ring end is placed around the barrel and against the face of the socket. 4. The gasket or hemp yarn in caulked slightly. 5. Molten pig lead is poured and then caulked. The correct sequence of these steps is....

MCQ->The joint used for joining the plain ends of cast iron pipes, is....

MCQ->Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & operator can be used to check whether a bit is ON. The & operator can be used to check whether a bit is OFF.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution