Question Set

1. Diffusion co-efficient of a metal in a solid solution depends upon its





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The velocity of sound in any gas depends upon its?....
QA->Pitch of a sound depends upon its?....
QA->Angular separation between two colours of the spectrum depends upon which thing?....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
MCQ->Diffusion co-efficient of a metal in a solid solution depends upon its....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->It is desired to concentrate a 20% salt solution (20 kg of salt in 100 kg of solution) to a 30% salt solution in an evaporator. Consider a feed of 300 kg/min at 30°C. The boiling point of the solution is 110°C, the latent heat of vaporisation is 2100 kJ/kg and the specific heat of the solution is 4 kJ/kg.K. The rate at which the heat has to be supplied in (kJ/min) to the evaporator is....
MCQ->Diffusion co-efficient generally depends upon the temperature, pressure & the nature of the components of the system. Its dimension is not the same as that of the....
MCQ->The diffusion co-efficient of Ni in Cu at 1000 K is 1.93 x 10-16 m2 . S-1 and it is 1.94 x 10-14 m2 S-1 at 1200 K. The activation energy (in k. J.mole-1 ) for the diffusion of Ni in Cu is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution