A digital gate can respond to an input signal in _______ .? ?->(Show Answer!)

Question Set

1. A digital gate can respond to an input signal in _______ .?

Show Similar Question And Answers

QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....

QA->The process of converting analogue signal into digital information is done by....

QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....

QA->Loss of ability of the body or some parts of the body to move; respond to stimuli or function is?....

QA->Which input device can not be used to work in MS - OFFICE ?....

MCQ->In the following passage some of the words have been left out. Read the passage carefully and choose the correct answer for the given blank out of the four alternatives. The conditions ______ which democracy can _______ are _______ to ________ but one thing is _______ that democracy is always a slow growth, whereas dictators may _____ to ______ and _______ a new _______ with dramatic success, under _______ conditions. under _______ conditions.....

MCQ->A digital gate can respond to an input signal in _______ .?....

MCQ->An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?....

MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....

MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution